R y Linux Mandrake 9.1

Porque la bola de cristal últimamente no me rula :-D

"Enga" proveedor de internet, modem/router, tarjeta de red o si conectas por usb,... ;-)

Saludoss

Tengo el combo R, mi modem es un Motorola SB4200 y me conecto con tarjeta de red. No se si necesitas algo más. Gracias.

después de probarlo todo y mil y una combinaciones, mi solución fue:
que lo pille todo automáticamente y reinicia el equipo con el cablemodem ya conectado, esto último no es de coña, hasta que lo reinicié me decía que no estaba conectado, a ver si te sirve

Mi tarjeta de red es una EP320XS y tengo los drivers bajados porque el XP no me la reconocia. Tambien vienen unos drivers para Linux, pero no se instalarlos porque aun estoy empezando con el. Os pongo el archivo de texto de los drivers a ver si me lo podeis explicar.

******* This document contains instructions on Linux driver installation for *******
******* SURECOM EP-320X-S/S-1 100/10M Ethernet PCI Adapter *******

The Linux driver for Myson MDT8xx compatible MAC chipset on
this adapter has been embedded into Linux systems since kernel
version 2.4.5, and this makes this adapter automatically detected
and installed with the driver supported by Linux system.

Therefore,

1. If your Linux kernel is still old version 2.2.x, please use
and refer the driver supported for kernel version 2.2.x in
\Linux\2.2.x directory on the driver diskette.

2. If your Linux kernel is version 2.4.x previous than version
2.4.5, please get the latest kernel file from the web site of The
Linux Kernel Archives (www.kernel.org/). Then, install and
re-compile the downloaded latest kernel file into your current
Linux system.

3. If your Linux kernel is or has been patched to version
above 2.4.5 but you have not enabled or configured the MTD8xx
compatible driver as dynamic loadable or embedded system module,
then you could follow the step 4 to enable the driver and
re-compile the kernel.

If you could use the console command "#locate fealnx.o" to
locate the module driver file or find the driver module file
fealnx.o in kernel source /usr/src/linux-2.4.x/drivers/net in
your Linux system, then you could load module into system by
console command "insmod fealnx.o" and then "ifconfig eth0 up" to
bring this adapter to work.

You could use console command "linuxconf" to configure
this adapter card too.

4. If your Linux kernel is any new version above than 2.4.5
(included) and it is a new installation, you can configure the
kernel by following console commands to enable the driver for
SURECOM EP-320X-S/S-1 100/10M Ethernet PCI Adapter.

#/usr/src/menuconfig

Enable the option of "Myson MTD-8XX PCI Ethernet support"
in "Ethernet (10 or 100 M bit)" of "Network device support" as a
loadable module or system default module.

#make dep

#make clean

#make bzImage

#cp /usr/src/linux-2.4.X/arch/i386/boot/bzImage /boot

Then, edit /etc/lilo.conf, run "/sbin/lilo", and then reboot
your Linux system. After new kernel has been rebooted, it will
automatically load the driver for this adapter.